Details

---

APPLICATION DIRECTION

1. Surfaces must be clean, dry and free of dirt, grease, oil or water.

2. For a neat finish, apply masking tape and remove it before construction adhesive skins over.

3. Cut tip off and puncture the internal foil seal with nozzle. Cut nozzle at 45° angle to desired bead-width and apply to substrate with cartridge gun.

4. Two-way contact (Lighter substrate bonding): Apply adhesive onto substrate to be bonded, press firmly, and pull apart. Allow to tack-off for 10 to 30 seconds and press firmly
together again. Contact areas should be tapped with a rubber mallet to ensure intimate contact.

5. One-way method (Heavier substrate bonding): Apply adhesive onto substrate to be bonded, press firmly, and securely fasten them together (clamp, nail, screw, etc.). Retain
fastening for a minimum of 24 hours.

6. Any wet or partially wet adhesive can be removed with a piece of cloth. Dried adhesive is best removed with scraper or by sanding.


OUR WEBSITE IS http://www.velocitydiy.com
CONTACT NUMBER IS +6014-9891223