Details

---

Styrenated polyester-based 2-component anchoring adhesive.

 

Fast curing

Non-sag, even overhead

ETA for anchoring in uncracked concrete

 

Usage

As a fast curing anchoring adhesive for all grades of:

Rebars / reinforcing steel

Threaded rods

Bolts and special fastening systems

In the following substrates:

Concrete

Hollow and solid masonry

Hard natural stone*

Solid rock*

* These substrates may vary greatly, in particular with regard to strength, composition, and porosity. Therefore, for each application, the suitability of Sika Sika AnchorFix® S adhesive must be tested by first applying the Product only to a sample area. Check-in particular bond strength, surface staining, and discoloration.

 

Advantages

Fast curing

Non-sag, even overhead

ETA for anchoring in uncracked concrete

Low wastage

 

Colour

Component A: white

Component B: black

Component A+B mixed: light grey

 

APPROVALS / STANDARDS

CE marking and Declaration of Performance as Bonded injection type anchor for use in uncracked concrete according to EAD 330499-00-0601, based on ETA-13/0721 of 18/05/2018 and certificate of constancy of performance of the construction product issued by the notified product certification body.

 

Shelf Life

12 months from date of production

 

All Sika AnchorFix® S cartridges have the expiry date printed on the label.

 

Storage Conditions

Stored properly in original, unopened, sealed, and undamaged packaging in dry conditions at temperatures between +5 °C and +25 °C. Protect from direct sunlight.

 

Density

~1.7 kg/l (component A+B mixed)

 

Mixing Ratio

Component A : component B = 10 : 1 by volume

 

Layer Thickness

3 mm max.

 

Sag Flow

Non-sag, even overhead

 

Product Temperature

Sika AnchorFix® S must be at a temperature of between +5 °C and +40 °C for application.

 

Ambient Air Temperature

+5 °C min. / +40 °C max.

 

Dew Point

Beware of condensation.

The substrate temperature during application must be at least 3 °C above the dew point.

 

SUBSTRATE QUALITY

Mortar and concrete must be at the required strength. No need to be 28 days old.

Substrate strength (concrete, masonry, natural stone) must be verified.

Pull-out tests must be carried out if the substrate strength is unknown.

The anchor hole must always be clean, dry, free from oil and grease, etc.

Loose particles must be removed from the holes.

Threaded rods and rebars have to be cleaned thoroughly from any oil, grease, or any other substances and particles such as dirt, etc